Hypertherm MAX80 --- This is a Plasma Arc Cutting System.
Capability - Using Air maximums are -
STEEL is 1" thick @ 8 inches/minute feed rate,
STAINLESS is 3/4" @ 15 in/min,
ALUMINUM 3/4" @ 8 in/min,
and for
Nitrogen on STANILESS 3/4" @ 10 in/min.
Requires 208 or 240 vac 60 Hz single phase.
Calcomp 1051 Plotter --- This is a sprocket fed drum plotter and
uses roll paper, vellum, or Mylar. Net drawing size 34" wide by length of roll.
DiAZiT42 42" Blueprinter --- UV flourescent tube blueprint machine.
Accepts a maximum of 42" wide paper. For diazo blueprint paper which developes with
ammonia.
New Hermes IRXK IV 299264 Manual Panel Engraver --- This is a manual
engraver that can be used with its base or on a very large panel.